woodjigs,

I love making woodworking jigs, it's fun and intereting to see what improvements of adaptions can be made to suite every different woodworker's needs. This jig has been around for many, many years and has changed little during that time. Rather than follow one of the plans that are readily available on-line, I decided I needed to make this jig to fit my own needs that may or may not be available in the plans someone else has created. My main objective was to ensure that both legs of the jig would straddle the insert throat plate in my saw, after all, that was the whole purpose... to build a jig that would accurately set or measure the distance from the top of a table saw blade to the top deck of my table saw and not to a measurement from the top of the blade to base of the throat plate, which is often the case.

To start off with I would need something thicker than 3/4 inch material for the main body of the jig because I wanted to use one of my plastic off-cuts of mitre slot material. I wanted something harder than many woods as this jig will be used a lot and I don't want the measuring arm to get dinted and chewed up by the table saw blades over time.

Watch this and other similar videos on YouTube - https://youtu.be/wbNhRwEAzTM

I started off with a block of wood that was 8 inches wide, 5 inches high and 1.25 inches deep. From this block, the first thing I did was to carefully cut a dado slot that would fit the plastic mitre slot material I wanted to use as the center measuring post....