Woodworking Jigs Videos

Adjustable Center Finder Jig / Center Marking Jig

It seems I am forever needing to cut a board into equal halves. I always have a tape measure handy, but sometimes it's just quicker and more accurate to use a center finding jig to find the center of a board, especially when they are strange widths ... like 13-9/16. Oh sure I can stop and figure this out in my head ... of use the metric scale, or just grab my center finder jig and have it done in a few seconds ... and anyway, it's fun to make these jigs and see if there are ways we can make them better and more useful.

Watch it on Youtube: https://youtu.be/54IMIBnKEnw

This version of the center finding jig has been around for many, many years but I have never seen an adjustable version ... not that there aren't some out there somewhere, just that I have never seen one. 

Quick and Handy Drill Press Angle Base Jig

Depending on how much you plan on using a jig will determine who much time you want to invest in making it. Some jigs that I use a lot I have put a lot of time into and made them with some built in features that make them easier and more accurate to use. This drill press angle jig is one that I will seldom use, so I want it to be sturdy but I'm not going to invest a ton of time into features to make it more usable. I have a pretty good hunch it will not get a lot of work because the number of times I have had to adjust my existing drill press table in the past 10 years, is about 3 times. Part of the reason for that is because who ever designed this drill press did a super poor job of making the adjustable table anything but easy to adjust ... but never mind, the new angle jig will solve that too.

2 Handy Circular Saw Jigs: Cross Cut Jig & Ripping Jig

The circular saw for some workers, like carpenters, is often their most used tools, and they even wear them out, For woodworkers it might also be their most important tool especially if they are new to woodworking and still working on a collection of power tools. For me, it was the second power tool (after my corded drill) that I purchased, and even though I no longer have that circular saw, to this day I still use my circ saw quite often for breaking down sheets of plywood to manageable sizes before running through the table saw, and even for longer boards that just need to be shortened so they are easier to maneuver in my workshop.

Watch it on Youtube: https://youtu.be/l0xkvxMUE7M

The first 8 foor ripping jig for the circular saw that I made is probably 20 years old and despite the fact I have gone through 2 circular saws since then, I still use that jig to this day .. that's how handy that jig is for breaking down sheets of plywood ...

Small Parts Holding Router Jig for the Router Table

Attempting to make small parts on any woodworking machine means extra care is needed and almost always some sort of a holding jig to keep your hands and fingers away from cutting bits and blades, which is why this jig is so handy. Router bit spin at very high speeds and for some, just the noise can be intimidating. The high speed spinning bits will normally produce excellent results, but if you ware working with smaller pieces, if then are not supported properly, can whip smaller pieces out of your hand in an instant so support for smaller pars means a safer way to cut, and equally as important ... a better quality cut because working safely means we can take our time to ensure better quality results.

Watch it on Youtube: https://youtu.be/f9Ckr73SKZ4

This small parts holding jig is easy to build and doesn't take a lot of time and when you are done you will appreciate how well it works for holding those small parts in the router table. I started off with some bits of plywood ...

Join Us On:

 YouTube
    Facebook
    Instagram
    Twitter
   Pinterest
   Google+