Picture Frame Making Videos

Picture Frame Glue-Ups - Video

OK, Now that you know how to cut picture frame material and make the angle cuts, now you need to put it all together. Gluing up smaller picture frames can be done with something a simple as black electrical tape wrapped around the picture frame after glue-up. The pressure of the tape will keep the corners together long enough to allow the frame to become rigid. Larger picture frames are another story ... the black electrical tape trick doesn't work so well.

In this case it is better to have some sort of a picture framing glue-up jig. The one shown in the video can be made quite easily, the plans are easy to find on the Internet and it doesn't take long to put it together. As usual ... there are some tricks. I decided to offset the center block so it makes it easier to use, AND I added wing-nuts to the ready bar so that the whole jig can be tightened up around the frame quickly and easily ... you don't want to fussing around too much glues like Titebond lll, it will start harding up on you (especially in warm weather) in minutes.


Making Picture Frame Material - Video

Now that you know how to make picture frames, wouldn't it be nice to be able to make your own picture frame material ... simply and easily ... on your own table saw?
The process of making picture frame material, also called molding can be as complex as you want to make it ... or you can make it simple. The molding I like to make are simple and when viewed in a cross section look like and "L" shape. They are easy to put together and look great.

I also ad splines in all for corners to add strength and an extra detail to the frames. I try to choose a contrasting wood so that the splines stand out somewhat from the frame molding.

... ...

It's important to remember that the face sides of your picture frame metial will need to be almost finished before you peform your final cuts. There is no easy way to run "L" shaped material through a planer and even funning it through a jointer will be tricky. All that should need to be done after the final cuts is to sand the face sides and begin the final 45 degree cuts as shown in the assembly  video.

Join Us On: