Top Banner

Free Catalog

Follow Us




×

Notice

The forum is in read only mode.

Table saw

  • Posts: 60

mhwitt74 replied the topic: Table saw

Tried that after I let it soak in WD40 for days. It didn't work. I am going to drill all the way through that little end and re-thread it. Last ditch effort I'm afraid. right now I am using clamps to hold the fence in place. I wonder if J.B. Weld would work?
#7
  • Posts: 269

Derek replied the topic: Table saw

JB weld will not hold it. There is too much pressure and torque involved on such a small area.

Derek
#8
  • Posts: 60

mhwitt74 replied the topic: Table saw

After some rigging it works like new.
#9
Attachments:
  • Posts: 60

mhwitt74 replied the topic: Table saw

Drilled out and tapped the nut that holds it all together. Used threaded rod and put a stop nut on the other end and tightened it down. Works great. Thanks for all the suggestions and support.
#10
  • Posts: 269

Derek replied the topic: Table saw

Awesome !!!!!! :)

Derek
#11
The following user(s) said Thank You: mhwitt74
  • Posts: 486

colin replied the topic: Table saw

I love this topic ... this is what these forums are all about, helping one another solve problems ... then showing how they were made.

Well done all of you !!

Colin
#12
The following user(s) said Thank You: mhwitt74